10 Leveling System
Warnings and Precautions
• Use the system in the intended manner. System forces and pressures can cause severe injury or death if used improperly or modified. Service work should only be performed by trained technicians.
• Do not attempt to operate the system when the vehicle is in motion.
• Visually confirm that all stabilizer legs are retracted prior to travel.
• The equalizer system is designed to deny extension or retraction if the ignition switch is in the (on) position. If equalizer system is extended and the ignition is turned on it will default and retract automatically.
• Make sure there are no obstructions in the path of the extend or retract paths of the stabilizer unit.
• Do not use the stabilizer legs to lift the unit to perform any kind of service work or to change the legs. The system is designed to stabilize the unit not to lift it off the ground.
• Do not go under vehicle while stabilizer legs are extended.
• Do not operate any system functions while anyone is under the coach.
• Do not allow excessive motion in the coach during stabilizer operation. This could cause the system to stabilize improperly.
• Modification of any factory-supplied item may result in denial of all warranty claims.
Parking the Coach
• Care must be taken when selecting a parking spot. Since the system is designed to provide stabilization, rather than leveling, park the coach on suitably level ground. The surface must be firm enough to prevent the stabilizer feet from sinking into the ground.
• Place the transmission in PARK and set the PARKING BRAKE.
• Prior to ANY system operation, visually confirm that the area above and below the stabilizers is clear of objects or obstructions.
• In order for the slide out(s) and/or stabilizers to extend/retract, turn the ignition key to the ON position. Deploy the stabilizers before extending Slide-Outs. Retract Slide-Outs and stabilizers will retract automatically when the ignition key is turned to the ON position.
Automatic Leveling System
Your Wayfarer is equipped with COMPUTERIZED LEVELING system
To operate the automatic hydraulic leveling mode:
1. Set park brake. Ignition must be turned off
2. Press the appropriate button to begin the levelling process.
3. During the leveling sequence, after the system has extended the appropriate jacks to level the vehicle the system will stabilize the vehicle.
To retract the jack in automatic hydraulic leveling mode:
NOTE: When the jacks are stored with the ignition in the ON position, the warning buzzer will sound until the jacks have retracted to the STORE position. If desired, the jacks can be stored with the ignition key in the accessory position. This will eliminate the warning buzzer while the jacks retracting.