Thetford Aqua-Magic Style II Owner's Manual

Operation

	To flush, press all the way down
	To add water, press halfway

Leaks:
- Back toilet: Check Water supply line connection at water valve. Resecure or retighten as necessary. If leaks persists from water valve, replace.
- Vacuum breaker leaks while flushing: replace Vacuum Breaker or water module, depending on model.
- Between closet flange and toilet: check flange nuts for tightness. If leaks continues, remove toilet and check flange height. Use Thetford spacers to adjust, if necessary, to 7/16" above floor. Replace flange seal.
Toilet won't hold water:
- Check for and remove any debris from blade/ball seal track.
- Check blade/ball seal compression with mechanism. If blade/ball seal is worn, replace.
Harder than normal pedal or hand lever:
- Apply light film of Thetford Toilet Seal Lubricant & Conditioner or silicone spray.
Poor flush:
- Pedals or hand levers must be held fully open during flush. A good flush should be obtained within 2 to 3 seconds. If problem persists, remove the water supply line and check flow rate. The flow rate should be at least ten quarts (9.5 liters) per minute.

Draining Method

Turn off RV's water supply. Drain toilet bowl. Disconnect supply line at water valve. Completely drain the toilet's water supply line.

Antifreeze Method

Use RV(potable) antifreeze only.

This toilet was designed to be compatible with Thetford brand holding tank deodorants.

Cleaning

Use Thetford Aqua-CleanTM non-abrasive cleaner with a soft bristle, non-abrasive bowl brush, sponge or soft cloth.

Do not use scourging powders, acids or concetrated cleaners, which can damage surfaces, plastic parts and rubber seals.